Kamis, 03 Maret 2011

rangkaian audio signal injektor/Tracer

This circuit can be used as a signal injector or signal tracer. This circuit is very helpful in trouble shooting audio circuits, when you need to test a circuit by injecting a signal and observe the output (by watching the oscilloscope or by hearing the loudspeaker ), or by tracing some points inside the circuit when an audio signal is applied to the input.

The circuit uses supply from 9 volts battery. An alligator clip is recommneded for the ground probes, so you can works with one hand to hold the board, and the other hand to target the test probes. The SPDT switch connected to the transitor and the earpiece is used to select the function, whether as a signal or a signal injector tracer.


Transistor 2n3904

This transistor is designed as a general purpose amplifier and switch. The useful dynamic range extends to 100 mA as a switch and to 100 MHz as an amplifier.
Transistor 2n3904 Pin
Absolute maximum rating
  • Collector-Emitter Voltage 40 V
  • Collector-Base Voltage 60 V
  • Emitter-Base Voltage 6.0 V
  • Collector Current - Continuous 200 mA
  • Operating and Storage Junction Temperature Range -55 to +150 °C

desain lampu marmo LED oleh salvinistile

SolusiProperti.com, Ini merupakan gaya desain pencahayaan dekoratif untuk interior yang merupakan bagian dari koleksi lampu hias Marmo LED dari Salvinistile.Sebuah produk yang menarik pada pencahayaan LED terlihat lebih kasar dan ketahanan dari lampu fluorescent terlihat kompak dan dapat menjadi lampu pijar.Fitur penting untuk dekorasi rumah anda dengan potensi untuk menerangi mode interior dengan gaya dan fungsi.

Lampu LED Marmo untuk dekoratif oleh Salvinistile. Koleksi bintang pencahayaan LED pada dekoratif sangat cocok untuk di dalam ruangan dan di luar ruangan, dan fitur inset lampu LED yang mengeluarkan binar surgawi.

Pencahayaan LED merupakan koleksi Meteor yang akan bersinar pada dinding interior Anda dengan deretan lampu kecil dan tersedia dengan teknologi opsional terang RGB LED dengan tampilan warna yang berubah untuk setiap gaya.[fps]

BOSTER RADIO PENERIMA FM

Here is a simple circuit of an FM booster that can be used to listen to programmes from distant FM stations clearly. This amplifier will pull in all distant FM stations clearly. The circuit is configured as a common-emitter tuned RF pre-amplifier wired around VHF/UHF transistor Q1.

rangkaian boster radio penerima FM
Skema rangkaian boster radio penerima FM

2SC2570. (Only C2570 is annotated on the transistor body.) Assemble the circuit on a good-quality PCB (preferably, glass-epoxy). Adjust input/ output trimmers (VC1/VC2) for maximum gain.

All capacitors are ceramic and 50V is the standard but the 25V types work fine too. Trimmer capacitors Tr1 and Tr2 (22pF) are adjusted for maximum gain. Input coil L1 consists of 4 turns of 20SWG enamelled copper wire over a 5mm diameter former. It is tapped at the first turn from the ground lead side. Coil L2 is similar to L1, but has only three turns. Pin configuration is shown in the diagram.


Component List:
  • R1 = 27K
  • R2 = 270 ohm
  • R3 = 1K
  • Tr1,Tr2 = 22pF, trimmer cap (15-40pF)
  • C1,C2 = 5.6pF
  • C3 = 0.001uF (1nF), ceramic
  • C4,C5 = 10pF, ceramic
  • C6 = 0.1uF (100nF), ceramic
  • Q1 = 2SC2498, 2SC2570, 2N5179, SK9139, or NTE10. NPN VHF/UHF transistor
  • L1 = 4 turns of 20SWG magnet wire, 5mm diameter. (so-called 3T+1)
  • L2 = 3 turns of 20SWG magnet wire, 5mm diameter.

SISTEM PEMBANGKIT LISTRIK

SISTEM PEMBANGKIT LISTRIK HYBRID DENGAN TENAGA SURYA DAN TENAGA ANGIN PUTARAN RENDAH KAPASITAS 500 WATT

Dalam rangka mengembangkan energi terbarukan yang hemat dan ramah lingkungan sesuai dengan peraturan pemerintah No. 15 tahun 2006 mengenai kebijakan energi nasional. Disisi lain kebutuhan energi listrik nasional yang dipenuhi oleh pemerintah baru bisa mencapai sekitar 30% – 40% dari kebutuhan energi nasional. Sementara itu kebutuhan energi alternatif yang berasal dari sumber energi angin dan surya teknologinya masih banyak di datangkan dari luar negeri. 

Hal tersebut, memotivasi Jurusan Teknik Mesin Universitas Pancasila untuk melakukan kegiatan penelitian di bidang energi terbarukan. Mengingat ketersediaan energi angin dan energi matahari yang cukup besar. Salah satu penelitian dari aplikasi energi angin dan energi matahari tersebut adalah turbin angin vertikal axis dengan daya sebesar 300 Watt dan panel solar cell sebesar 200 Watt.

Dengan memanfaatkan penelitian ini, sistem pembangkit tenaga hybrid dimungkinkan untuk mengembangkan energi terbarukan yang hemat dan ramah lingkungan. Disamping itu, dengan pemakaian energi terbarukan yang ramah lingkungan dapat memperoleh insentif berupa sertifikat reduksi emisi gas CO2 . 

UM3561-simple sound effek generator circuit

This is a very simple. The IC UM3561 produces four differen sound effects, the output at Pin 3 being amplified by the transistor 2N2222. A 64 ohm loudspeaker can be substituted in place of the 56 ohm resistor and 8 ohm loudspeaker.

Sound Effects Generator circuitSkema Rangkaian Sound Effects Generator

The 2 pole 4 way switch controls the sound effects. Position 1 (as drawn) being a Police siren, position 2 is a fire engine sound, 3 is an ambulance and position 4 is a machine gun effect.

Note:
The IC sound generator UM3561 is now available in a kt from Maplin Electronics. Click here for the link.